Retén SA
El perfil SA es un retén radial, para sellado de eje, compuesto por una única jaula metálica exterior, con una jaula interior adicional, que proporciona mayor rigidez estructural, y un labio primario —de estanqueidad con muelle integrado.
CHARACTERISTICS
Buena rigidez radial, particularmente para grandes diámetros.
Buena estabilidad cuando se ensambla, evitando que se salga el retén.
Versión económica cuando se trata de un elastómero caro.
Modern primary sealing lip with low radial forces
Adecuado para el uso en combinación con juntas axiales (V-ring, RE).
Caja interior adicional para reforzar la rigidez estructural.
See our gnstallation guide for oil seals to perform a correct installation of the seal.
| ø | ºC | bar | m/s |
|---|---|---|---|
|
10-790 mm |
-55ºC/225ºC |
≤0.3 bar |
≤10 m/s |
MATERIALS
Elastomer
NBR 70-75 Shore A
FKM 75-80 Shore A
VMQ 70-75 Shore A
ACM 70-75 Shore A
EPDM 70-75 Shore A
HNBR 70-75 Shore A
Metal Box
AISI 1060-90 - AISI 304 - AISI 316
Pier
AISI 1060-90 - AISI 302 - AISI 304 - AISI 316
| DIN 3760 BO |
|---|
|
SIMRIT – B2/B2U |
|
STEFA – DB |
|
NATIONAL – 45 |
|
TRELLEBORG – TRB |
TOLERANCES FOR THE OUTSIDE DIAMETER OF THE OIL SEAL
| Housing diameter | Metal cage | Elastomeric coating | Lace |
|---|---|---|---|
| ≤50.0 | +0.10 / +0.20 | +0.15 / +0.30 | +0.20 / +0.40 |
| <50.0 ≤80.0 | +0.13 / +0.23 | +0.20 / +0.35 | +0.25 / +0.45 |
| <80.0 ≤120.0 | +0.15 / +0.25 | +0.20 / +0.35 | +0.25 / +0.45 |
| <120.0 ≤180.0 | +0.18 / +0.28 | +0.25 / +0.45 | +0.30 / +0.55 |
| <180.0 ≤300.0 | +0.20 / +0.30 | +0.25 / +0.45 | +0.30 / +0.55 |
| <300.0≤500.0 | +0.23 / +0.35 | +0.30 / +0.55 | +0.35 / +0.65 |
| <500.0 ≤630.0 | +0.23 / +0.35 | +0.35 / +0.65 | +0.40 / +0.75 |
TOLERANCE FOR THE INNER DIAMETER OF THE SEAL
The inner diameter of the sealing lip is always smaller than the shaft diameter. Depending on the shaft size, the sealing lip diameter is generally between 0.8 and 3.5 mm smaller than the shaft diameter.
EN 
ES 
CA 
FR 
IT 
