Retén TGW
El perfil TGW es un retén de doble labio compuesto de una única jaula de metal con un revestimiento de goma, un labio de sellado primario con muelle integrado y un labio guardapolvo que actúa de protector contra la acumulación de suciedad desde el exterior. Dispone de un estriado en el exterior para facilitar el montaje. El labio de estanqueidad tiene estrias con un sentido de rotación bidireccional, para seguir el mismo giro del eje y controlar la expulsión de lubricante.
- Good static sealing.
- Compensation of different thermal expansion.
- Reduced risk of fretting corrosion.
- A higher surface roughness of the bore is allowed.
- Sealing for low- and high-viscosity fluids
- Modern primary sealing lip with low radial forces
- Protection against unwanted airborne contaminants
- Grooved outside for ease of assembly.
- Sealing lip with bidirectional helix-shaped grooves
See our gInstallation guide for oil seals to perform a correct installation of the seal.
| ø | ºC | bar | m/s |
|---|---|---|---|
|
10-790 mm |
-55ºC/225ºC |
≤0.3 bar |
≤10 m/s |
MATERIALS
Elastomer
NBR 70-75 Shore A
FKM 75-80 Shore A
VMQ 70-75 Shore A
ACM 70-75 Shore A
EPDM 70-75 Shore A
HNBR 70-75 Shore A
Metal casing
AISI 1060-90 - AISI 304 - AISI 316
Spring
AISI 1060-90 - AISI 302 - AISI 304 - AISI 316
TOLERANCES FOR THE OUTSIDE DIAMETER OF THE OIL SEAL
| Housing diameter | Metal cage | Elastomeric coating | Housing with grooves |
|---|---|---|---|
| ≤ 50.0 | +0.10 / +0.20 | +0.15 / +0.30 | +0.20 / +0.40 |
| >50.0 ≤80.0 | +0.13 / +0.23 | +0.20 / +0.35 | +0.25 / +0.45 |
| >80.0 ≤120.0 | +0.15 / +0.25 | +0.20 / +0.35 | +0.25 / +0.45 |
| >120.0 ≤180.0 | +0.18 / +0.28 | +0.25 / +0.45 | +0.30 / +0.55 |
| >180.0 ≤300.0 | +0.20 / +0.30 | +0.25 / +0.45 | +0.30 / +0.55 |
| >300.0 ≤500.0 | +0.23 / +0.35 | +0.30 / +0.55 | +0.35 / +0.65 |
| >500.0 ≤630.0 | +0.23 / +0.35 | +0.35 / +0.65 | +0.40 / +0.75 |
TOLERANCE FOR THE INNER DIAMETER OF THE SEAL
When not under pressure, the inside diameter of the sealing lip is always smaller than the shaft diameter. The difference between the two dimensions is known as interference or pre-fitting. Depending on the shaft size, the sealing lip diameter is estimated to be between 0.8 mm and 3.5 mm smaller. It will depend on the setting chosen by each manufacturer.
EN 
ES 
FR 
