Retén VA
El perfil VA es un retén radial, para sellado de eje, compuesto por una única jaula metálica exterior, con una jaula interior adicional, que proporciona mayor rigidez estructural, y un labio primario de estanqueidad sin muelle.
CHARACTERISTICS
Rigidez radial superior, especialmente para grandes diámetros.
Good assembly stability to prevent rebound effect
Sealing for high-viscosity fluids
Primary sealing lip design that ensures low levels of friction and heat generation
Labio de estanqueidad sin muelle.
See our gnstallation guide for oil seals to perform a correct installation of the seal.
| ø | ºC | bar | m/s |
|---|---|---|---|
|
10-790 mm |
-55ºC/225ºC |
≤0.3 bar |
≤10 m/s |
MATERIALS
Elastomer
NBR 70-75 Shore A
FKM 75-80 Shore A
VMQ 70-75 Shore A
ACM 70-75 Shore A
EPDM 70-75 Shore A
HNBR 70-75 Shore A
Metal Box
AISI 1060-90 - AISI 304 - AISI 316
Pier
AISI 1060-90 - AISI 302 - AISI 304 - AISI 316
| DIN 3760 CO |
|---|
|
SOG – 301 |
TOLERANCES FOR THE OUTSIDE DIAMETER OF THE OIL SEAL
| Housing diameter | Metal cage | Elastomeric coating | Lace |
|---|---|---|---|
| ≤50.0 | +0.10 / +0.20 | +0.15 / +0.30 | +0.20 / +0.40 |
| <50.0 ≤80.0 | +0.13 / +0.23 | +0.20 / +0.35 | +0.25 / +0.45 |
| <80.0 ≤120.0 | +0.15 / +0.25 | +0.20 / +0.35 | +0.25 / +0.45 |
| <120.0 ≤180.0 | +0.18 / +0.28 | +0.25 / +0.45 | +0.30 / +0.55 |
| <180.0 ≤300.0 | +0.20 / +0.30 | +0.25 / +0.45 | +0.30 / +0.55 |
| <300.0≤500.0 | +0.23 / +0.35 | +0.30 / +0.55 | +0.35 / +0.65 |
| <500.0 ≤630.0 | +0.23 / +0.35 | +0.35 / +0.65 | +0.40 / +0.75 |
TOLERANCE FOR THE INNER DIAMETER OF THE SEAL
The inner diameter of the sealing lip is always smaller than the shaft diameter. Depending on the shaft size, the sealing lip diameter is generally between 0.8 and 3.5 mm smaller than the shaft diameter.
EN 
ES 
CA 
FR 
IT 
