VG Shaft Seal
The VG profile is a springless shaft seal consisting of a single metal case with a rubber coating and a primary sealing lip without a spring. It features external ribs to facilitate installation.
CHARACTERISTICS
- Good static sealing.
- Compensation of different thermal expansion.
- A higher surface roughness of the bore is allowed.
- Sealing for high-viscosity fluids
- Primary sealing lip that generates low levels of friction and heat
- Knurled exterior for ease of assembly.
See our gnstallation guide for oil seals to ensure proper installation of the VG shaft seal
TOLERANCE FOR THE INNER DIAMETER OF THE SEAL
| ø | ºC | bar | m/s |
|---|---|---|---|
|
20-790 mm |
-55ºC/225ºC |
≤0.3 bar |
≤10 m/s |
MATERIALS
Elastomer
NBR 70-75 Shore A
FKM 75-80 Shore A
VMQ 70-75 Shore A
ACM 70-75 Shore A
EPDM 70-75 Shore A
HNBR 70-75 Shore A
Metal Box
AISI 1060-90 - AISI 304 - AISI 316
| MANUFACTURER | EQUIVALENCE |
|---|---|
|
INA |
G |
TOLERANCES FOR THE OUTSIDE DIAMETER OF THE OIL SEAL
| Housing diameter | Metal cage | Elastomeric coating | Lace |
|---|---|---|---|
| ≤ 50.0 | +0.10 / +0.20 | +0.15 / +0.30 | +0.20 / +0.40 |
| >50.0 ≤80.0 | +0.13 / +0.23 | +0.20 / +0.35 | +0.25 / +0.45 |
| >80.0 ≤120.0 | +0.15 / +0.25 | +0.20 / +0.35 | +0.25 / +0.45 |
| >120.0 ≤180.0 | +0.18 / +0.28 | +0.25 / +0.45 | +0.30 / +0.55 |
| >180.0 ≤300.0 | +0.20 / +0.30 | +0.25 / +0.45 | +0.30 / +0.55 |
| >300.0 ≤500.0 | +0.23 / +0.35 | +0.30 / +0.55 | +0.35 / +0.65 |
| >500.0 ≤630.0 | +0.23 / +0.35 | +0.35 / +0.65 | +0.40 / +0.75 |
TOLERANCE FOR THE INNER DIAMETER OF THE SEAL
When not under pressure, the inside diameter of the sealing lip is always smaller than the shaft diameter. The difference between the two dimensions is known as interference or pre-fitting. Depending on the shaft size, the sealing lip diameter is estimated to be between 0.8 mm and 3.5 mm smaller. It will depend on the setting chosen by each manufacturer.
EN 
ES 
CA 
FR 
IT 
