The SGW profile is a high-pressure, dual-lip shaft seal consisting of a single metal case with a rubber coating, a primary sealing lip with an integrated spring, and a dust lip that acts as a protective barrier against external dirt buildup. The sealing lip features bidirectional grooves, designed to follow the shaft’s rotation in both directions and help control lubricant expulsion. It also includes external ribbing to facilitate installation.
See our Installation guide for oil seals to perform a correct installation of the seal.
| ø | ºC | bar | m/s |
|---|---|---|---|
|
10-790 mm |
-55ºC/225ºC |
≤0.3 bar |
≤10 m/s |
Elastomer
NBR 70-75 Shore A
FKM 75-80 Shore A
VMQ 70-75 Shore A
ACM 70-75 Shore A
EPDM 70-75 Shore A
HNBR 70-75 Shore A
Metal casing
AISI 1060-90 - AISI 304 - AISI 316
Spring
AISI 1060-90 - AISI 302 - AISI 304 - AISI 316
| MANUFACTURER | EQUIVALENCE |
|---|---|
|
PAULSTRA |
IEWV |
|
CORTECO |
BADRWX7 |
Housing diameter | Metal cage | Elastomeric coating | Housing with grooves |
|---|---|---|---|
| ≤ 50.0 | +0.10 / +0.20 | +0.15 / +0.30 | +0.20 / +0.40 |
| <50.0 ≤80.0 | +0.13 / +0.23 | +0.20 / +0.35 | +0.25 / +0.45 |
| <80.0 ≤120.0 | +0.15 / +0.25 | +0.20 / +0.35 | +0.25 / +0.45 |
| <120.0 ≤180.0 | +0.18 / +0.28 | +0.25 / +0.45 | +0.30 / +0.55 |
| <180.0 ≤300.0 | +0.20 / +0.30 | +0.25 / +0.45 | +0.30 / +0.55 |
| <300.0 ≤500.0 | +0.23 / +0.35 | +0.30 / +0.55 | +0.35 / +0.65 |
| <500.0 ≤630.0 | +0.23 / +0.35 | +0.35 / +0.65 | +0.40 / +0.75 |
When not under pressure, the inside diameter of the sealing lip is always smaller than the shaft diameter. The difference between the two dimensions is known as interference or pre-fitting. Depending on the shaft size, the sealing lip diameter is estimated to be between 0.8 mm and 3.5 mm smaller. It will depend on the setting chosen by each manufacturer.
