The SCW profile is a single-lip radial seal consisting of a single metal cage with a rubber coating and a primary sealing lip with an integrated spring. The sealing lip has grooves with a bidirectional rotation direction, to follow the same rotation of the shaft and control the expulsion of lubricant.
Please refer to our seal installation guide to fit the seal correctly.
When not subjected to pressure, the inner diameter of the sealing lip is always smaller than the shaft diameter. The difference between these two dimensions is known as interference or preload fit. Depending on the shaft size, the sealing lip diameter is estimated to be between 0.8 mm and 3.5 mm smaller. This will vary depending on the fit chosen by each manufacturer.
| Housing diameter | Metal cage | Elastomeric coating | Housing with grooves |
|---|---|---|---|
| Ø ≤ 50 | +0.10 / +0.20 | +0.15 / +0.30 | +0.20 / +0.40 |
| 50 < Ø ≤ 80 | +0.13 / +0.23 | +0.20 / +0.35 | +0.25 / +0.45 |
| 80 < Ø ≤ 120 | +0.15 / +0.25 | +0.20 / +0.35 | +0.25 / +0.45 |
| 120 < Ø ≤ 180 | +0.18 / +0.28 | +0.25 / +0.45 | +0.30 / +0.55 |
| 180 < Ø ≤ 300 | +0.20 / +0.30 | +0.25 / +0.45 | +0.30 / +0.55 |
| 300 < Ø ≤ 500 | +0.23 / +0.35 | +0.30 / +0.55 | +0.35 / +0.65 |
| 500 < Ø ≤ 630 | +0.23 / +0.35 | +0.35 / +0.65 | +0.40 / +0.75 |
NBR 70-75 Shore A
FKM 75-80 Shore A
VMQ 70-75 Shore A
ACM 70-75 Shore A
EPDM 70-75 Shore A
HNBR 70-75 Shore A

