The KG profile is a springless seal composed of a single metal cage with a rubber coating, a primary sealing lip without spring and a dust lip that acts as a protector against the build-up of external dirt. It has a grooved outer casing to facilitate assembly.
Please refer to our seal installation guide to fit the seal correctly.
When not under pressure, the inner diameter of the sealing lip is always smaller than the shaft diameter. The difference between the two dimensions is known as interference or pre-load. Depending on the shaft size, the sealing lip diameter is estimated to be between 0.8 mm and 3.5 mm smaller. This will depend on the fit chosen by each manufacturer.
| Diámetro | Volumen de interferencia (labio principal) | Límite desviación (labio principal) | Volumen de interferencia (labio adicional) | Límite desviación (labio adicional) |
|---|---|---|---|---|
| 5 – 30 | 0.7 – 1.0 | +0.2 – 0.3 | 0.3 | ±0.15 |
| 30 – 60 | 1.0 – 1.2 | +0.2 – 0.5 | 0.4 | ±0.20 |
| 60 – 80 | 1.2 – 1.4 | +0.2 – 0.6 | 0.5 | ±0.25 |
| 80 – 130 | 1.4 – 1.8 | +0.2 – 0.8 | 0.6 | ±0.30 |
| 130 – 250 | 1.8 – 2.4 | +0.3 – 0.9 | 0.7 | ±0.35 |
| 250 – 400 | 2.4 – 3.0 | +0.4 – 1.0 | 0.9 | ±0.40 |
| Diámetro del alojamiento | Jaula de metal | Revestimiento elastomérico | Encaje |
|---|---|---|---|
| Ø ≤ 50 | +0.10 / +0.20 | +0.15 / +0.30 | +0.20 / +0.40 |
| 50 < Ø ≤ 80 | +0.13 / +0.23 | +0.20 / +0.35 | +0.25 / +0.45 |
| 80 < Ø ≤ 120 | +0.15 / +0.25 | +0.20 / +0.35 | +0.25 / +0.45 |
| 120 < Ø ≤ 180 | +0.18 / +0.28 | +0.25 / +0.45 | +0.30 / +0.55 |
| 180 < Ø ≤ 300 | +0.20 / +0.30 | +0.25 / +0.45 | +0.30 / +0.55 |
| 300 < Ø ≤ 500 | +0.23 / +0.35 | +0.30 / +0.55 | +0.35 / +0.65 |
| 500 < Ø ≤ 630 | +0.23 / +0.35 | +0.35 / +0.65 | +0.40 / +0.75 |
NBR 70-75 Shore A
FKM 75-80 Shore A
VMQ 70-75 Shore A
ACM 70-75 Shore A
EPDM 70-75 Shore A
HNBR 70-75 Shore A

