The VG1 profile is a springless seal composed of a single metal cage with a rubber coating and a narrower primary sealing lip without a spring, designed for applications with a radial space limitation. It has external grooves to facilitate installation. Particularly suitable for applications where the housing material is subject to a higher coefficient of thermal expansion.
Please refer to our seal installation guide to fit the seal correctly.
When not under pressure, the inner diameter of the sealing lip is always smaller than the shaft diameter. The difference between the two dimensions is known as interference or pre-load. Depending on the shaft size, the sealing lip diameter is estimated to be between 0.8 mm and 3.5 mm smaller. This will depend on the fit chosen by each manufacturer.
| Diameter | Interference volume (primary lip) | Deviation limit (primary lip) | Interference volume (secondary lip) | Deviation limit (secondary lip) |
|---|---|---|---|---|
| 5 – 30 | 0.7 – 1.0 | +0.2 – 0.3 | 0.3 | ±0.15 |
| 30 – 60 | 1.0 – 1.2 | +0.2 – 0.5 | 0.4 | ±0.20 |
| 60 – 80 | 1.2 – 1.4 | +0.2 – 0.6 | 0.5 | ±0.25 |
| 80 – 130 | 1.4 – 1.8 | +0.2 – 0.8 | 0.6 | ±0.30 |
| 130 – 250 | 1.8 – 2.4 | +0.3 – 0.9 | 0.7 | ±0.35 |
| 250 – 400 | 2.4 – 3.0 | +0.4 – 1.0 | 0.9 | ±0.40 |
| Housing diameter | Metal cage | Elastomeric coating | Housing with grooves |
|---|---|---|---|
| Ø ≤ 50 | +0.10 / +0.20 | +0.15 / +0.30 | +0.20 / +0.40 |
| 50 < Ø ≤ 80 | +0.13 / +0.23 | +0.20 / +0.35 | +0.25 / +0.45 |
| 80 < Ø ≤ 120 | +0.15 / +0.25 | +0.20 / +0.35 | +0.25 / +0.45 |
| 120 < Ø ≤ 180 | +0.18 / +0.28 | +0.25 / +0.45 | +0.30 / +0.55 |
| 180 < Ø ≤ 300 | +0.20 / +0.30 | +0.25 / +0.45 | +0.30 / +0.55 |
| 300 < Ø ≤ 500 | +0.23 / +0.35 | +0.30 / +0.55 | +0.35 / +0.65 |
| 500 < Ø ≤ 630 | +0.23 / +0.35 | +0.35 / +0.65 | +0.40 / +0.75 |
NBR 70-75 Shore A
FKM 75-80 Shore A
VMQ 70-75 Shore A
ACM 70-75 Shore A
EPDM 70-75 Shore A
HNBR 70-75 Shore A

