The VG profile is a springless shaft seal consisting of a single metal case with a rubber coating and a primary sealing lip without a spring. It features external ribs to facilitate installation.
See our Installation guide for oil seals to perform a correct installation of the VF shaft seal.
| ø | ºC | bar | m/s |
|---|---|---|---|
|
20-790 mm |
-55ºC/225ºC |
≤0.3 bar |
≤10 m/s |
Elastomer
NBR 70-75 Shore A
FKM 75-80 Shore A
VMQ 70-75 Shore A
ACM 70-75 Shore A
EPDM 70-75 Shore A
HNBR 70-75 Shore A
Metal casing
AISI 1060-90 - AISI 304 - AISI 316
| MANUFACTURER | EQUIVALENCE |
|---|---|
|
INA |
G |
Housing diameter | Metal cageJaula de metal | Elastomeric coating | Housing with grooves |
|---|---|---|---|
| ≤ 50.0 | +0.10 / +0.20 | +0.15 / +0.30 | +0.20 / +0.40 |
| >50.0 ≤80.0 | +0.13 / +0.23 | +0.20 / +0.35 | +0.25 / +0.45 |
| >80.0 ≤120.0 | +0.15 / +0.25 | +0.20 / +0.35 | +0.25 / +0.45 |
| >120.0 ≤180.0 | +0.18 / +0.28 | +0.25 / +0.45 | +0.30 / +0.55 |
| >180.0 ≤300.0 | +0.20 / +0.30 | +0.25 / +0.45 | +0.30 / +0.55 |
| >300.0 ≤500.0 | +0.23 / +0.35 | +0.30 / +0.55 | +0.35 / +0.65 |
| >500.0 ≤630.0 | +0.23 / +0.35 | +0.35 / +0.65 | +0.40 / +0.75 |
When not under pressure, the inside diameter of the sealing lip is always smaller than the shaft diameter. The difference between the two dimensions is known as interference or pre-fitting. Depending on the shaft size, the sealing lip diameter is estimated to be between 0.8 mm and 3.5 mm smaller. It will depend on the setting chosen by each manufacturer.
